Installation - HIKVISION DS-2CE78D0T-IT3FS User Manual

2 Installation

Before you start
Make sure that the device in the package is in good

condition and all the assembly parts are included.
Make sure that all the related equipment is power-off

during the installation.
Check the specification of the products for the

installation environment.
Check whether the power supply is matched with

your power output to avoid the damage.
Make sure the wall is strong enough to withstand

three times the weight of the camera, and the
mount.
If the wall is cement, insert expansion bolts before

installing the camera. If the wall is wooden, use
self-tapping screws to secure the camera.
If the product does not function properly, contact

your dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.1 Installation of Type I Camera
2.1.1 Ceiling/Wall Mounting without Junction Box
Before you start:
The installation of ceiling mounting and wall mounting
are similar. Following takes ceiling mounting as an
example.
Steps:
1. Disassemble the camera by rotating the camera to
align the notch to one of the line, as shown in the
figure below.
2. Pry the mounting base by using a flat object, for
example, a coin.
3. Drill the screw holes and the cable hole (optional)
on the ceiling.
4. Attach the mounting base to the ceiling and secure
it with supplied screws. For cement ceiling, you
need to install the expansion bolts at first.
Figure 2-3 Attach the Mounting Base to the Ceiling
5. Route the cables through the cable hole, or the side
opening.
Figure 2-1 Dissemble the Camera
Figure 2-2 Pry the Mounting Base
Expansion Bolts
Screws