Command Parameters - Nvidia MSTFLINT Manual

-use_image_guids
-use_image_ps
-use_image_rom
-v
-vsd <string>
-y[es]
Note 1. The -mac and -macs options are applicable only to Mellanox Technologies Ethernet adapter
and switch devices.
Note 2. When accessing SwitchX via I2C or PCI, the -override_cache_replacement flag must be set.

Command Parameters

Common FW Update and Query
b[urn] Burn flash
q[uery] Query misc. flash/firmware characteristics, use "full" to get more information.
[full]
v[erify] Verify entire flash
swreset SW reset the target un-managed switch device. This command is supported only in the
In-Band access method.
sign_with_ Sign image with HMAC.
hmac
Expansion ROM Update:
brom <ROM-file>
drom
rrom <out-file>
qrom
Initial Burn, Production:
Misc FW Image operations:
ri <out-file>
dc [out-file]
dh [out-file]
checksum|cs
timestamp|ts <set|query|
reset>
[timestamp] [FW version]
Burn (guids/uids/macs) as appears in the given image.
Commands affected: burn
Burn vsd as appears in the given image - do not keep existing VSD on flash.
Commands affected: burn
Do not save the ROM which exists in the device.
Commands affected: burn
Version info.
Write this string, of up to 208 characters, to VSD when burn.
Non interactive mode - assume answer "yes" to all questions.
Commands affected: all
Burn the specified ROM file on the flash.
Remove the ROM section from the flash.
Read the ROM section from the flash.
Query ROM in a given image.
Read the fw image on the flash.
Dump Configuration: print fw configuration file for the given image.
Dump Hash: print hash file for the given image.
Perform MD5 checksum on firmware.
Set/query/reset firmware timestamp.
53