Using Mstconfig To Set Sr-Iov Parameters; Using Mstconfig To Set Preboot Settings - Nvidia MSTFLINT Manual

# mstconfig 41:00.0
Device #1:
----------
Device type: ConnectX3Pro
PCI device: 41:00.0
Configurations:
LINK_TYPE_P1
LINK_TYPE_P2
Apply new Configuration? ? (y/n) [n] : y
Applying... Done!
-I- Please reboot machine to load

Using mstconfig to Set SR-IOV Parameters

In order to set SR-IOV parameters through mstconfig, use the following command line:
# mstconfig -d <device> set [SRIOV_EN=<0|1>] [NUM_OF_VFS=<NUM>]
Example: Turning on SR-IOV and enabling 8 Virtual Functions per Physical Function:
# mstconfig -d 41:00.0
Device #1:
----------
Device type:
PCI device:
Configurations:
SRIOV_EN
NUM_OF_VFS
Apply new Configuration? ? (y/n) [n] : y Applying... Done!
-I- Please reboot machine to load

Using mstconfig to Set Preboot Settings

For a full description of the preboot configurable parameters refer to
their Parameters under "Preboot Settings".
Example: Enable boot option ROM on port 1, set boot retries to 3 and set the boot protocol to PXE.
# mstconfig -d 41:00.0
LEGACY_BOOT_PROTOCOL_P1=1
Device #1:
----------
Device type: ConnectX3Pro
PCI device: 41:00.0
Configurations:
BOOT_OPTION_ROM_EN_P1
BOOT_RETRY_CNT_P1
LEGACY_BOOT_PROTOCOL_P1
Apply new Configuration? ? (y/n) [n] : y
Applying... Done!
-I- Please reboot machine to load
Example: Configure VLAN ID to 3 on port 2
set LINK_TYPE_P1=1 LINK_TYPE_P2=1
Next Boot
ETH(2)
ETH(2)
set SRIOV_EN=1 NUM_OF_VFS=8
ConnectX4
41:00.0
Next Boot
0
0
set BOOT_OPTION_ROM_EN_P1=1 BOOT_RETRY_CNT_P1=3
Next Boot
False(0)
0
2
New
IB(1)
IB(1)
new configurations.
New
1
8
new configurations.
New
True(1)
3
1
new configurations.
Supported Configurations and
27