Nvidia MSTFLINT Manual page 14

Internal Ref.
No.
2084837 Description: Setting the speeds (50GbE and 100GbE) for the new devices (Connect-
X 6 and above, Quantum switches and above) requires specifying the number of
lanes for the speed:
mstlink -d <dev> --speeds [50G_2X | 50G_1X | 100G_2X | 100G_4X]
For PRBS mode, to work with PAM4 speeds, use the same speed naming for
(50GbE, and 100GbE).
Workaround: N/A
Keywords: mstlink
Discovered in Version: 4.14.0-1
2071210 Description: mstconfig query for the BOOT_INTERRUPT_DIS TLV shows a wrong
value in the "current value" field.
Workaround: Use "next boot" indication to see the right value.
Keywords: mstconfig
Discovered in Version: 4.14.0-1
2001890 Description: The argparse module is installed by default in Python versions =>2.7
and >=3.2. In case an older Python version is used, the argparse module is not
installed by default and therefore must be manually installed.
Workaround: N/A
Keywords: Python, argparse module
Discovered in Version: 4.13.3-2
1923665 Description: Force Mode does not work when using mstlink in ConnectX-6
InfiniBand adapter cards.
Workaround: N/A
Keywords: mstlink, Force Mode, ConnectX-6 IB
Discovered in Version: 4.13.3-2
1918749 Description: mstlink tool displays a wrong speed when using ETH cables on
ConnectX-6 adapter cards.
Workaround: N/A
Keywords: mstlink
Discovered in Version: 4.13.0
1755062 Description: To execute firmware reset on a multi-host card, mstfwreset must be
run simultaneously on each one of the hosts. Running mstfwreset simultaneously
on the same host is incorrect and may result in server hanging.
Workaround: Cold reboot for the server
Keywords: mstfwreset
Issue
14