Nvidia MSTFLINT Manual page 51

-banks <banks>
-blank_guids
-clear_semaphore
-d[evice] <device>
-dual_image
-flash_params
<type,log2size,num_o
f_flashes>
--flashed_version
-guid <GUID>
-guids <GUIDs...>
-h[elp]
-hh
Set the number of attached flash devices (banks)
Burn the image with blank GUIDs and MACs (where applicable). These values
can be set later using the "sg" command (see details below).
Commands affected: burn
Force clear the flash semaphore on the device. No command is allowed when
this flag is used.
NOTE: May result in system instability or flash corruption if the device or
another application is currently using the flash. Exercise caution.
Device flash is connected to.
Commands affected: all
Make the burn process burn two images on flash (previously default
algorithm). Current default failsafe burn process burns a single image (in
alternating locations).
Commands affected: burn
Use the given parameters to access the flash instead of reading them from
the flash.
Supported parameters:
• Type: The type of the flash, such as: M25PXxx, M25Pxx, SST25VFxx,
W25QxxBV, W25Xxx, AT25DFxxx, S25FLXXXP
• log2size: The log2 of the flash size
• num_of_flashes: the number of the flashes connected to the device
When specified, only flashed fw version is fetched
Commands affected: query
GUID base value. 4 GUIDs are automatically assigned to the following values:
guid -> node GUID
guid+1 -> port1
guid+2 -> port2
guid+3 -> system image GUID
NOTE: port2 guid will be assigned even for a single port HCA - The HCA
ignores this value.
Commands affected: burn, sg
4 GUIDs must be specified here. The specified GUIDs are assigned to the
following fields, repectively: node, port1, port2 and system image GUID.
NOTE: port2 guid must be specified even for a single port HCA. The HCA
ignores this value. It can be set to 0x0.
Commands affected: burn, sg
Prints this message and exits
Prints extended command help
51