Table of Contents
Advertisement
Chapter 3
Suspend Mode
After the selected period of system inactivity, all devices except the CPU
shut off. Settings: Disabled, 1 Min, 2 Min, 4 Min, 8 Min, 12 Min, 20 Min,
30 Min, 40 Min and 1 Hour.
HDD Power Down
If HDD activity is not detected for the length of time specified in this field,
the hard disk drive will be powered down while all other devices remain
active. Settings: Disabled and 1 Min through 15 Min.
Soft-Off by PWR-BTTN
This feature allows users to configure the power button function. Settings
are:
Instant-Off
Delay 4 Sec.
Wake-Up by PCI Card, Power On by Ring, Wake Up On LAN, USB KB Wake-
Up From S3
These items specify whether the system will be awakened from power saving
modes when activity or input signal of the specified hardware peripheral or
component is detected.
Note: To use the function of "Power On by Ring" and "Wake Up On
LAN", you need to install a modem/LAN card supporting power on
function.
CPU Thermal-Throttling
The item allows you to specify the percentage of CPU speed to which it will
slow down when the CPU temperature reaches the predetermined overheat-
ing limit. Settings range from 12.5% to 87.5% at 12.5% increment.
The power button functions as a normal power-on/-
off button.
When you press the power button, the computer
enters the suspend/sleep mode, but if the button is
pressed for more than four seconds, the computer
is turned off.
3-24
Advertisement
Table of Contents
