Page 1
MICRO-STAR INTERNATIONAL MS-6382 (v2.X) Micro ATX Mainboard Version 2.0 G52-MA00563...
Page 2
FCC-B Radio Frequency Interference Statement Notice 1 Notice 2 VOIR LA NOTICE DINSTALLATION AVANT DE RACCORDER AU RESEAU. Micro-Star International MS-6382 Tested to comply with FCC Standard For Home or Office Use...
Page 3
Edition March 2002 Copyright Notice MICRO-STAR INTERNATIONAL Trademarks ® ® ® ® ® ® ® Revision History Revision Revision History Date...
Getting Started Chapter 1. Getting Started Getting Started VIA KT266A & VT8233A TOPICS Mainboard Specification Mainboard Layout Quick Components Guide...
Chapter 2 Central Processing Unit: CPU ® make sure the CPU has a heat sink and a cooling fan attached on the top to prevent overheating. Open Lever Sliding Plate Cut edge Close Lever Overheating will seriously damage the CPU and system, always make sure the cooling fan can work properly to protect the CPU from overheating.
Page 15
Hardware Setup 600MHz and above then While replacing the CPU, always turn off the ATX power supply or unplug the power cable of the ATX WARNING! power supply from grounded outlet first to ensure the safety of CPU.
Page 16
Chapter 2 Memory PC1600 or PC2100 Note: The DDR DIMM slots DO NOT support PC2700 modules. PC2100 PC1600 (DDR266) (DDR200) Clock 133MHz 100MHz Peak Bandwidth 2133MB/s 1600MB/s...
Hardware Setup Back Panel Parallel Midi/Joystick (optional) Mo us e Keyboard COM A L-out L-in MIC COM B ® ® ® Pin Definition SIGNAL DESCRIPTION PS/2 Mouse (6-pin Female)
Page 20
Chapter 2 ® ® ® Pin Definition SIGNAL DESCRIPTION PS/2 Keyboard (6-pin Female) USB Port Description SIGNAL DESCRIPTION 1 2 3 4 5 6 7 8 USB Ports...
Page 21
Hardware Setup Pin Definition 1 2 3 4 5 SIGNAL DESCRIPTION 6 7 8 9 9-Pin Male DIN Connectors Line Out Line In 1/8 Stereo Audio Connectors Line Out Line In...
Page 22
Chapter 2 Pin Definition SIGNAL DESCRIPTION 2-10...
Page 25
Hardware Setup IDE1 IDE2 IDE1 IDE2 If you install two hard disks on cable, you must configure the second drive to Slave mode by setting its jumper. Refer to the hard disk documentation supplied by hard disk vendors for jumper setting instructions.
Page 27
Hardware Setup SENSOR +12V CFAN1 SENSOR +12V SFAN1 Note: 1. Always consult the vendor for proper CPU cooling fan. 2. CPU Fan supports the fan control. You can install the PC Alert utility that will automatically control the CPU Fan speed accord- ing to the actual CPU temperature.
Page 28
Chapter 2 PLED1 PLED2 JGL1 3-Pin LED 2-Pin LED Green Color Green Color Orange Color Orange Color Green:Full-on Mode Dual Color Orange: Sleep Mode 2-16...
Page 30
Chapter 2 ® JAUD1 Pin Definition SIGNAL DESCRIPTION CAUTION!!! If you dont want to connect to the front audio header, pins 5 and 6, 9 and 10 have to be shorted by jumper caps in order to have signal output directed to the rear audio ports.
Page 31
Hardware Setup ® JFP2 JFP1 JFP2 Pin Definition Signal Signal JFP1 Switch/LED Front Panel Electrical Connection SIGNAL DESCRIPTION 2-19...
Hardware Setup Jumpers Clear CMOS Keep CMOS JBAT1 You can clear CMOS by shorting 2-3 pin while the system is off. Then return to 1-2 pin position. Avoid clearing the CMOS while the system is on; it will WARNING! damage the mainboard. 2-21...
Page 34
Chapter 2 100MHz 133MHz While replacing the CPU, always turn off the ATX power supply or unplug the power cable of the ATX WARNING! power supply from grounded outlet first to ensure the safety of CPU. 2-22...
Page 36
Chapter 2 Order 1 Order 2 Order 3 Order 4 PCI Slot 1 INT A# INT B# INT C# INT D# PCI Slot 2 INT B# INT C# INT D# INT A# PCI Slot 3 INT C# INT D# INT A# INT B# 2-24...
Chapter 3 Entering Setup Press DEL to enter SETUP Control Keys < ↑ > Move to the previous item < ↓ > Move to the next item < ← > Move to the item in the left hand < → > Move to the item in the right hand <Enter>...
Page 63
AWARD BIOS Setup ® ® Ø Disabled Data read or written by the CPU is only directed to the PCI VGA devices palette registers. Enabled Data read or written by the CPU is directed to both the PCI VGA devices palette registers and the ISA VGA devices palette registers, permitting the palette registers of both VGA devices to be identical.
Chapter 3 Set Supervisor/User Password About Supervisor Password & User Password: 3-32...
Page 69
Glossary Glossary Glossary ACPI Advanced Configuration & Power Interface AGP Accelerated Graphics Port BIOS basic input/output system Cache Chipset...
Page 70
Glossary CMOS complementary metal-oxide semiconductor DIMM dual in-line memory module SIMM (single in-line memory module) DRAM Dynamic RAM Dynamic RAM (DRAM) Memory Technologies Peak Type First Used Clock Rate Bus* Width Volts Bandwidth FPM (60,70ns) 1990 25MHz 64 bits 200 MBps EDO (50,60,70ns) 1994 40MHz...
Page 71
Glossary ECC Memory error correcting code memory IDE Integrated Drive Electronics IEEE 1394 FireWire iLink IrDA Infrared Data Association LAN local area network LED light emitting diode LPT line printer terminal...
Page 72
Glossary PCI Peripheral Component Interconnect PnP Plug and Play POST Power On Self Test PS/2 Port USB universal serial bus Virus...
Need help?
Do you have a question about the MS-6382 and is the answer not in the manual?
Questions and answers