Advertisement
Maintenance
Replacing the saw
It is essential to wear protective gloves when changing the blade of the tool:
1. Remove the corner plate (27) from the mobile blade guide.
2. Remove the protective guard (28).
3. Turn the lever (29) towards the position "-".
4. Remove the blade (30).
5. Insert the new blade taking care to observe the cutting direction and placing it between the
blade guide rollers and also between the rubber pulleys (31).
6. Turn the lever (29) towards the position "+".
7. When the lever (29) reaches the end of its stroke the blade will automatically position itself for
cutting when the motor begins to turn.
8. Replace the guard (28) and the plate (27) of the mobile blade guide.
Note:
During the first 4–6 cuts (after replacing the blade) perform slight cutting pressures to increase
the duration and effectiveness of the blade thereafter.
After each working shift
Carefully clean all parts of the machine to remove shavings and cutting residue.
Periodically
Check the length of the electric motor brushes and make sure they are efficient. If they are
less than 6 mm long, they must be replaced with original new ones.
The gear transmission requires no maintenance since it runs on long life lubricants.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61917
Page 8
02
2021-1
Advertisement
