Baroness LM56 Technical Information
Blade/cut adjustment procedure
Hide thumbs
Also See for LM56:
- Installation manual (12 pages) ,
- Information leaflet (4 pages) ,
- Technical information (5 pages)
Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Baroness LM56
Summary of Contents for Baroness LM56
- Page 1 Technical Information Leaflet TIL: 014 LM56/66 Blade/Cut Adjustment Procedure...
- Page 2 Before commencing any blade adjustments it is very important that the cutting units are thoroughly cleaned and dry. To check that the blades are cutting correctly use a strip of paper as shown. With the strip of paper held square to the bottom blade, rotate the cutting cylinder and see if the blades will cut the paper.
- Page 3 Please note that Baroness blades are designed to run non-contact and so do not over tighten them. If you are unable to achieve an acceptable cut with just a light contact after performing the above adjustments then the blades have become a little blunt and so will need back- lapping.
Need help?
Do you have a question about the LM56 and is the answer not in the manual?
Questions and answers