Table of Contents
Advertisement
Available languages
Available languages
Cleaning
1.
Do not remove the connector of whisk when cleaning the appliance, otherwise the milk
foam will be not good enough.
2.
Remove the jug from the power base.
3.
Separate the lid and the silicon ring from the jug.
4.
Flush and clean the jug with warm soapy water. This should be done immediately after
each use.
5.
Rinse the lid and silicon ring in warm water· Wash in soapy water if necessary.
6.
Clean the jug body with a soft damp cloth. NEVER use harsh cleaning agents or abrasive
materials
7.
Wash the whisks in warm soapy water and dry thoroughly. Store in a safe place.
NOTE:
The Milk Frother or any of its accessories are NOT dishwasher safe.
Troubleshooting
Issue
Indicator light doesn't work/jug
doesn't work
Jug doesn't work after opera-
tion
Motor doesn't work
No heating
Charring
Warranty
Champion Nordic guarantees that this product is free from manufacturing defects in terms of materials
and workmanship during a period of 2 years in Sweden, Norway, Denmark and Finland. This warranty
period begins on the day the product is purchased or delivered. Champion Nordic has no obligation to
repair or replace products that are not accompanied by a valid proof of purchase. This warranty applies
only to products purchased and used for home use and does not cover damage resulting from abuse,
failure to comply with the instructions from Champion Nordic, cases in which the product has been mo-
dified or subjected to unauthorized repair, improper packaging on the part of the owner, normal wear
and tear, or improper handling on the part of a transport company.
Correct Disposal of this product
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources.
Reason
•
Plug is not inserted properly
•
Jug isn't connected to power base
properly
•
No power in the jack
•
Problem with components
•
Jug temperature is too high
•
Jug is damaged with immersion in water
•
Jug not cleaned in good time after use,
milk locks the mechanism.
•
Motor damaged
•
Machine is damaged
•
Dosage of milk either too little or too
much
•
Jug was reused without cleaning/rinsing
•
Actual voltage is much lower than speci-
fied voltage
Champion ®
Makadamgatan 14 I 254 64 Helsingborg I Sweden
info@champion.se
Solution
•
Re-insert plug
•
Remove jug and replace correctly
•
Check the electric circuit
•
Repair or replace
•
Rinse cold water inside the jug to
reduce temperature
•
Repair or replace
•
Clean and move the shaft sleeve
of motor by hand to loosen it.
•
Repair or replace
•
Repair or replace
•
Ensure the milk is over the min
mark and not pass the max mark
•
Always clean after each use
•
Ensure you use the appropriate
voltage
EN
4
Advertisement
Table of Contents
