CSL DualCom Pro Series Quick Manual & Instruction Manual page 10

STEP 4. TESTING
Before leaving site you must test the DualCom Pro 2 device as per these steps.
Place device on
test at the ARC
and send a range
of signals from the
panel
You should also simulate path failures at part of the testing process.
Whilst in the
quiescent/normal
state section, press
Place
button A to get to
device
the connectivity
on test at
menu. The LEDs
the ARC
(LED 1 = single-path,
LED 1 & 2 = dual-path)
will be lit
IF YOU HAVE PURCHASED A DUAL-PATH DEVICE, YOU MUST ENSURE BOTH PATHS ARE CONNECTED
IF YOU DISCONNECT BOTH PATHS AT THE SAME TIME, MY BASE WILL ONLY SHOW THE FIRST PATH IN
MY BASE APP
My Base provides Installers with the ability to manage and configure DualCom Pro 2 devices on a
handy App/Web portal.
Simply download CSL My Base from your appropriate App store and obtain log-in information from CSL
(or the CSL web administrator within your company) to access these great features:
View path
status
Amend panel
connection
View Alarms
(you must still check with your
ARC that alarms are being
received by them)
Perform a path test by
tapping button C whilst
in quiescent/normal
state
Hold button B
for 5 seconds.
Once let go, LED
1 will go red to
show path 1 is in
simulated fail
BEFORE LEAVING SITE.
FAILURE. THIS IS EXPECTED BEHAVIOUR.
Check signal
strength
Change pin
configuration
Test
Alarm
Amend Smart
Reporting
LED 3 will flash to show
signals are being sent
For dual-path devices,
hold button C for 5
seconds. Once let
go, LED 2 will go red
to show path 2 is in
simulated fail. Check
signals are received
at the ARC
View panel
connection status
Check ATS path
availability
Invert fault
relay
Add estate
name
10
Check signals are received
at the ARC
Tap button B & C to
restore each path.
LEDs 1 and/or 2 will
go green. Check
path failure signals
are received at the
ARC
IP
Configure static IP
information
Remotely upgrade
device firmware
Configure
outputs