CSL MiniAir Quick Manual And Instruction Manual

Hide thumbs Also See for MiniAir:

MiniAir

QUICK GUIDE &

INSTRUCTION MANUAL

Table of Contents

Need help?

Do you have a question about the MiniAir and is the answer not in the manual?

Page 1 MiniAir QUICK GUIDE & INSTRUCTION MANUAL...
Page 3: Led Status
Figure 1 - MiniAir 12v DC Power Supply Ground To panel’s Digi-Modem To Armed Status Output To Keyswitch Zone Twist to fit Figure 2 - LED Indications LED STATUS Flashing every 5 Flashing every second 3 Fast flashes seconds Establishing connection...
Page 4: Step 3. Bell Output
Quick Guide This section provides basic information to enable you to install and commission the MiniAir quickly. Additional information is contained in the main guide together with troubleshooting information on the CSL website. Before installation or testing, the ARC should be contacted and system placed on test.
Page 5: Troubleshooting
Configure a programmable output from the panel to Activate (switch to ground) when the panel is armed and to deactivate when disarmed – refer to manufacturer’s guide Wire the programmable output to IN (white wire) on the MiniAir Please note: A relay may be required when configuring a panel with a latching keyswitch...
Page 6: Specifications
Suitable for use in alarm systems complying to: Standards EN50136-1:2012 SP1 ATS Classification: EN50136-1-1:1998 ATS 1/Grade 1 SUPPORT for more information on MiniAir or other DualCom products please contact CSL Technical Support: UK Tel: +44 (0)1895 474 444 Ireland Tel:...