Fan Installation; Making The Electrical Connections - GE 20390 User Manual

MAKING THE ELECTRICAL CONNECTIONS

Prepare wiring from outlet box. Be sure there are no
deep cuts in the exposed copper wiring as it could
break off in the terminals. Cut and strip 1/2 in. of
insulation from end of each wire if necessary. (Fig 1)
NOTE: Do NOT strip any more than 1/2 in. of insulation
from end of wires as this could cause a short at any
time.
IMPORTANT: Wiring must not come down and around
the face of powerplug receptacle.
Electrical wiring (refer to Fig 2 and Fig 3 as necessary)
can be made as follows:
Connect BLACK wire from ceiling to terminal in
powerplug receptacle marked L1. Secure the wire by
tightening the small set screw.
Connect WHITE wire from ceiling to terminal in
powerplug receptacle marked W. Secure the wire by
tightening the small set screw.
Connect GREEN/BARE wire from ceiling to terminal in
powerplug receptacle marked G. Secure the wire by
tightening the small set screw.
Reference the wiring configuration diagrams below for
other wiring options into the terminal. L1 is the only
active live terminal on this fan.
NOTE: If you do not have standard wiring configurations
and have questions about the wiring in your outlet box,
please contact a qualified electrician.
WIRING DIAGRAM 1:
Typical Wiring Configuration for 1 Wall Switch
W
(L1)
G-ground
(L2)
8

Fan Installation

Fig 2
(CLOSE-UP VIEW of TERMINALS on Powerplug Receptacle)
WIRING DIAGRAM 2:
Typical Wiring Configuration for 2 Wall Switches
black (live)
white
green
This Fan is supplied with a remote control receiver
and transmitter to operate the fan and light. The
L2 terminal is not activated on this fan. The red wire
can be capped off with a wire nut or inserted into L2.
Only 1 wall switch will be operational.
Fig 1
black wire
powerplug
-
receptacle
L1
L2
L1
Fig 3
black wire
WHITE
(L1)
W
G-ground
(L2)
outlet box
ground
(green/
bare)
wire
G
white
wire
W
green/bare
wire
G
W
white wire
black(live 1)
white
green
red (live 2)