Required Tools And Materials; Decommissioning And Disposal - Siemens RUGGEDCOM RMC40 Installation Manual

6
Figure 1.1
POWER LED
LINK/ACT LED
Power Supply Terminal
Communication Ports
1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM RMC40:
AC or DC power cord (16 AWG)
CAT-5 Ethernet cables
Flathead screwdriver
Phillips screwdriver
4 x #8-32 screws
1.4

Decommissioning and Disposal

Proper decommissioning and disposal of this device is important to prevent malicious
users from obtaining proprietary information and to protect the environment.
Decommissioning
This device may include sensitive, proprietary data. Before taking the device out of
service, either permanently or for maintenance by a third-party, make sure it has
been fully decommissioned.
For more information, refer to the associated Configuration Manual.
RUGGEDCOM RMC40
Installation Manual, 04/2021, C79000-G8976-1009-09
Chassis Ground Terminal
RUGGEDCOM RMC40
Tools/Materials
Illuminates when power is being supplied to the device.
State
Green
Off
Indicate the connection status of the fiber optic Ethernet ports.
State
Yellow (Solid) Link is established
Yellow (Blinking) Port activity
A pluggable terminal. For more information, refer to:
• "Connecting Power (Page 9)"
• "Power Supply Specifications (Page 17)"
Receive and transmit data. For more information about the
various ports available for the RUGGEDCOM RMC40, refer to
"Communication Ports (Page
For connecting power to the device.
For connecting the device to the network.
For mounting the device to a DIN rail.
For mounting the device to a panel.
For mounting the device to a panel.
Introduction
1.3 Required Tools and Materials
Description
Power is on
Power is off
Description
13)".
Purpose
3