Download Print this page

Electrical Connections; Troubleshooting - GE Tetra EdgeStrip Installation Manual

Led lighting system

Advertisement

Tetra
EdgeStrip
®

Electrical Connections

NOTE: Refer to the power supply installation instructions for loading and remote mounting information.
NOTE: Do not use connectors pre-filled with silicone grease/mineral base protective grease or use silicone grease
to seal connections.
1
Connect modules using twist-on wire connectors
or in-line (IDC) connectors. Join white wires
together and red striped wires together.
NOTE: Additional supply wire may be necessary to
bridge electrical connections.
To LED System
Run a wire from the Power Supply and connect
1
to the first LED module on the strip.
Must be used with a class 2 24 Volt DC
Power Supply. .
NOTE: All electrical connections should be suitably protected from mechanical damage and the environment. Seal all
connections in locations that may be exposed to water with electrical grade RTV silicone.

Troubleshooting

Symptom
Solution
Row of modules
Check wire connections to power supply to ensure red stripe-to-red and white-to-black or blue connections.
does not light
Check row-to-row polarity connections.
Sign does not light
Check input and output voltage and check power supply input/output connections.
Check polarity connections.
Ensure the overall length of the Tetra
Individual modules
Remove module and replace with another working module.
do not light
Modules are dim
Ensure the overall length of the Tetra
Ensure the length and gauge of the supply wire is equal to or below the recommended remote mounting distance.
Power
Supply
2
Cap all exposed wires with appropriate end
caps or apply electric grade (non-corrosive)
silicone for additional weather protection.
Connect the red stripe wire (+) of the LED
2
system to the red wire (+) of the power supply.
Connect the white wire (-) of the LED system to
the black or blue wire (-) of the power supply.
NOTE: All electrical connections should be
made within the box sign.
LED System does not exceed the maximum load.
®
LED system does not exceed the maximum load.
®
3
Installation Guide
To Power Supply

Advertisement

loading

This manual is also suitable for:

Gebi71-2Gebi50-2Gebi41-2Gebi32-2