Settings - Abtus ABT4650 RouteScan / AGI2 Instruction Manual

15

5.4 Settings

The settings screen tab is where the scan recording parameters are defined.
Start Angle, [degrees]

End Angle, [degrees]

Increment (Resolution) [degrees].

Absolute/Relative

In the settings tab, the mode can be changed between 'ABS' and 'REL' by clicking
on the button at the bottom of the screen.
In absolute mode, super elevation is taken into account. In relative mode, the
measurement are relative to the rails.
Up to three settings can be defined allowing up to three segments with different
start and end angles and increments to be recorded in a single scan and saved in
one file.
:
4650-60 Issue 01