1. Manuals
  2. Brands
  3. Abtus Manuals
  4. Measuring Instruments
  5. ABT 4610 Laser Offset Gauge
  6. Instruction manual

Abtus ABT 4610 Laser Offset Gauge Instruction Manual

Allows the user to take height and distance offset readings from the running rails to a desired object or position
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
ABT4610
Laser Offset Gauge
Instruction Manual
4610-1 Issue 04

Advertisement

Table of Contents
loading

Related Manuals for Abtus ABT 4610 Laser Offset Gauge

Summary of Contents for Abtus ABT 4610 Laser Offset Gauge

  • Page 1 ABT4610 Laser Offset Gauge Instruction Manual 4610-1 Issue 04...

  • Page 2: Table Of Contents

    1.0 Index Index Item List Specification Getting Started Overview Assembly Measuring Super Elevation Operating the Gauge and Software Turn on the Control Unit by pressing and holding the on button (please refer to manufacturers instructions as control units can vary). Maintenance Before Each Use Every 3 Months...

  • Page 3: Item List

    4.0 Getting Started Overview The ABT 4610 is the latest edition to the Abtus data-logging range. The purpose of the product is to allow the user to take height and distance offset readings from the running rails to a desired object or position.
  • Page 4 clamped into position, the measurement laser is then attached. The Datum Laser Gauge measures height and distance offsets by using the measurement laser. The laser has five location holes on the vertical and horizontal arms of the gauge, by measuring an object from at least two of these positions the PDA software is able to calculate the height and distance offset of the object/location to the running edge of the rail.

  • Page 5: Assembly

    Assembly Unfold the Vertical Beam and locate the free end of the Diagonal Beam into the Locking Knob in the middle of the Vertical Beam. Ensure that the Locking Knob is located into the recess of the Locking Plate (as shown in figure 1).

  • Page 6: Measuring Super Elevation

    Measuring Super Elevation The super elevation is displayed in positive or negative degrees (°) on the inclinometer screen. The SE is negative when the adjustable end is higher. Operating the Gauge and Software 1. Turn on the Control Unit by pressing and holding the on button (please refer to manufacturers instructions as control units can vary).
  • Page 7 Calculates Datum using pivot sockets A, B & C. Calculates Platform using pivot sockets A, B & C. Calculates Overhead using pivot sockets A, D & E. To obtain measurement values enter each laser reading taken from the specified pivot sockets (see above), and a 'Tilt' (Super Elevation) reading from the inclinometer into PDA and press calculate.

  • Page 8: Maintenance

    Maintenance Before Each Use Check that the bearing surfaces that are in contact with the rail are clean and can move freely Ensure that the vertical beam locks firmly into place Ensure all batteries are fully functioning Every 3 Months Visually check for damage Annual To ensure that the accuracy of your ABT4610 remains within specified limits, it...

Table of Contents