Table of Contents
Advertisement
9
5.2 Single Point Check
The Abtus Gauge Interface 2 software provides a user interface/screen to check
single points.
The position of the laser beam can now be controlled either by rotating the laser
housing by hand or by the buttons 4, 5, 6, 8, and 9
The user has the following input options:
1. Zero position button. It takes the Routescan to 0deg
2. Laser ON
3. Laser OFF
4. Move the spindle +20deg
5. Move the spindle -20deg
6. Move the spindle from 0 to 180deg
7. Target pole option. That option adds 300mm to Y axis to compensate the
Target pole.
8. Move the spindle -1deg
9. Move the spindle +1deg
The Measure button gives an instant measurement. The purple boxes show the
measurement results for the single point:
X & Y position in mm
o
Laser distance in mm
o
Angle in degrees
o
Super elevation in mm
o
Gauge in mm
o
Note – it is not possible to send commands from the Control Unit when the
Laser Housing is rotating. Ensure that the Laser Housing is stationary
before clicking any buttons
4650-60 Issue 01
Advertisement
Table of Contents
