Table of Contents
Advertisement
Dust Collection
DO NOT operate the Model G0718 with-
out an adequate dust collection system.
This machine creates substantial amounts
of wood dust while operating. Failure to use
a dust collection system can result in short
and long-term respiratory illness.
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
To connect a dust collection hose:
1.
Fit the 4" dust hose over the dust port and
secure it in place with a hose clamp.
2.
Tug the hose to make sure it does not come
off.
Note: A tight fit is necessary for proper per-
formance.
Model G0718 (Mfd. Since 12/10)
Power Connection
After you have completed all previous setup
instructions and circuit requirements, the machine
is ready to be connected to the power supply.
To avoid unexpected startups or property dam-
age, use the following steps whenever connect-
ing or disconnecting the machine from the power
supply.
Connecting Power
1.
Turn the machine power switch OFF.
2.
Insert the power cord plug into a matching
power supply receptacle. The machine is
now connected to the power source.
Figure 21. Connecting power.
Disconnecting Power
1.
Turn the machine power switch OFF.
2.
Grasp the molded plug and pull it completely
out of the receptacle. DO NOT pull by the
cord as this may damage the wires inside.
Figure 22. Disconnecting power.
-19-
Advertisement
Table of Contents
