MAIN COMPONENTS LIST
A
Mandrel
B
Nosepiece
C
Lock Nut
D
Nose Housing
E
Nose Housing Nut
F
Mandrel Lock
*for complete tool explosion and Bill of Material please see service
ACCESSORIES CHANGING INSTRUCTIONS
Always wear approved hearing and eye protections at all times when using installation
equipment.
WARNING: Before adjusting tool, always remove the battery pack.
Mounting the mandrel and nosepiece
Select the correct mandrel (A) and nosepiece (B) for the blind nut (K) to be
•
installed.
Loosen the nose housing nut (E), Remove the nose housing (D).
•
Press the mandrel lock (F), Loosen and remove the mandrel (A).
•
Screw the correct mandrel (A) into Spin Pull Head (H) while pressing the mandrel
•
lock (F). Lock the mandrel (A)
Loosen the lock nut (C) and unscrew and remove the nosepiece (B) and Lock nut
•
(C)
Screw the Lock nut (C) onto the correct nosepiece (B) and screw the nosepiece (B)
•
into the nose housing (D) lightly.
Adjust the position of the nosepiece (B) according to the blind nut (K) to be
•
installed. The length of mandrel protruding from the top of blind nut (K) to be 0-
0.5mm.
Tighten the lock nut (C) by a spanner properly.
•
4
G
Spin Pull Head Case
H
Spin Pull Head
I
FR Lever
J
Mast Housing
K
Nut
manual