Advertisement
Quick Links
Advertisement
Related Manuals for Stanley NEOBOLT COLLAR CROPPER
Summary of Contents for Stanley NEOBOLT COLLAR CROPPER
- Page 1 USER MANUAL NEOBOLT COLLAR CROPPER NEOBOLT COLLAR CROPPER...
-
Page 3: Table Of Contents
E N G L I S H CONTENT 1. Safety ................................2 2. Technical specifications ..........................2 3. Package contents: ............................2 4. Cutter setup: ..............................3 5. Cutter use ...............................4 6. Tool disassembly ............................5 7. Tool assembly ..............................6 8. Tool maintenance ............................7... -
Page 4: Safety
Alum: 190 Hydraulic pressure (bar) Seel: 490 Cropper Stroke (mm) Cropper weight (kg) 0.48 0.86 Cropper Dia/Length (mm) 27 / 108 38 / 71 60 / 150 43 / 98 48 / 118 3. PACKAGE CONTENTS One Neobolt collar cropper assembly. -
Page 5: Cutter Setup
E N G L I S H Neobolt cropper components: Neobolt size 65120-00061 65120-00060 65110-00059 65110-00054 65110-00055 Item Quantity 3/8” 12mm 12mm/ 1/2” 1/2” 5/8” O-ring* 6510-00463 65110-00460 65110-00431 65110-00431 65110-00432 Jaw* 65110-00327 65110-00213 65110-00171 65110-00171 65110-00309 Cutter* 65110-00326 65110-00211 65110-00452 65110-00167 65110-00311... -
Page 6: Cutter Use
E N G L I S H • Thread retaining nut clockwise into tool body (hand tight – Do not use wrench), until it bottoms out. • Cycle tool twice and retighten retaining nut if needed. • Verify that pintail from Neobolt pin fits inside the jaws. •... -
Page 7: Tool Disassembly
E N G L I S H • Place tool against fastener to be cut. Pin tail must be fully inserted into cutter. Tool must be aligned with the fastener to be removed. INCORRECT • Press trigger to start cutting. Release button once collar is fully cut. •... -
Page 8: Tool Assembly
E N G L I S H 7. TOOL ASSEMBLY • Slide o-ring into jaw holder as shown. • Apply light coat of moly-lithium grease to inside of cutter. • Place jaws into jaw holder as shown, keeping them aligned with side grooves. •... -
Page 9: Tool Maintenance
E N G L I S H • Slide retaining nut into nose housing and thread nose housing (hand tight – Do not use wrench) into cutter. 8. TOOL MAINTENANCE For optimal performance, it is critical that the tool is kept clean and in good working order. Cleaning frequency will depend on usage and operating conditions. - Page 10 ® ProSet , Stavex and T-Lok are registered trademarks of Stanley Black & Decker, Inc. and its affiliates. The names and ® ® ® logos of other companies mentioned herein may be trademarks of their respective owners. Data shown is subject to change without prior notice as a result of continuous product development and improvement policy.