Remove And Replace Inlet Banjo Valve - Cornelius UF-1 POST-MIX VALVE Operator's Manual

UF-1 Post-Mix Valve Operation Manual
R A R I
EMOVE ND EPLACE
R
EMOVAL
1. Remove dispensing valve covers. Lift front cover straight up for 1/
4 inch and pull for-ward. Slide rear cover forward 1/4 inch and
lift off.
2. Disconnect dispensing valve wiring harness connector from unit
wiring harness connector.
3. Remove valve from dispenser by releasing the latch, then
depressing the top valve dovetail, and pulling valve forward.
4. Remove solenoid cover by lifting up.
5. Remove solenoid wires from solenoid. Re-move solenoid by
releasing snap fit with thumbs and pulling forward.
6. Remove nozzle and bottom plate.
7. Lay valve on its back with five screws facing you.
8. Remove five screws and remove valve head, being careful not to
lose the return springs from Banjo.
9. Remove Banjo from valve body.
NOTE: Banjo now may be installed either direction since it
now has a double–sided seat. You can turn Banjo
over and actually use it as a spare part.
I
NSTALLATION
NOTE: Always wet the Banjo with water before installing.
Clean all parts thoroughly before assembly.
1. Install the Banjo, and actuator arm and assemble dispensing
valve by reversing dis-assembly procedure. Tighten the five
screws evenly to ensure proper sealing of the Banjo.
2. Install the return springs.
NOTE: Always make sure bale wire (U shaped wire) is in
place before installing valve on block.
3. Install dispensing valve on unit by inserting valve on block fitting
and pushing in until tight. Then push up on the bottom dovetail
plate until the latch has snapped into place.
4. Connect dispensing valve wiring harness connector to unit wir-
ing harness connector.
5. Install dispensing valve cover.
Publication Number: 315222002OPR
B V
NLET ANJO ALVE
- 16 - © 2017-2021, Marmon Foodservice Technologies, Inc.