Hardware Introduction - Moxa Technologies NPort 5600-8-DTL Series Quick Installation Manual

Hardware Introduction

Top and Rear Views
Front View
Reset Button
Use a pointed object to hold the reset button down for at least five
seconds to load the factory defaults. Release the reset button when the
Ready LED stops blinking.
LED Indicators
The LED indicators on the top panel are used to display the status as
follows:
Name Color
PWR red
off
Ready green
off
Fault red
off
Link green
off
green
Function
Power is on.
Power is off.
Steady: NPort is operational
Blinking: NPort is responding to NPort
Administrator "Locate" function or NPort is
resetting to factory default
Power is off or fault condition exists.
IP conflict or DHCP or BOOTP server did not
respond properly.
No fault condition detected.
Steady: Network is connected; no data is being
transmitted.
Blinking: Network is connected; data is being
transmitted.
Ethernet cable is disconnected or has a short.
Serial port has been opened by server side
software.
- 3 -