IKEA TVÄRSÄKER Manual page 37

Hide thumbs Also See for TVÄRSÄKER:
Table of Contents

Advertisement

Available languages

Available languages

EN
adjusting Oven Temperatures
Your appliance has been factory calibrated and
tested to ensure accurate baking temperatures. For
the first few uses, follow your recipe times and tem-
perature recommendations carefully. If you think the
oven is cooking too hot or too cool for your recipe
times, you may adjust the control so the oven cooks
hotter or cooler than the oven temperature dis-
played.
The oven temperature may be increased as much as
+35°F (+19°C) or decreased -35°F (-19°C) from the
factory calibrated settings.
NOTE
Do not use oven thermometers such as those
found in grocery stores to check the temperature
settings inside your oven.
These oven thermometers may vary as much as
20 to 40°F degrees from actual temperatures.
To increase or decrease the oven temperature
by 20°f:
1. Press and hold Bake until the control produces
an audible tone (about 6 seconds). The factory
offset temperature of 0 (zero) should appear in
the display.
2. Enter 2 0 using numeric keypad.
3. To offset the oven by -20°F, press self clean to
toggle between + and -.
4. Press OK/STaRT to accept change.
IMpORTaNT
Oven temperature adjustments will not change the
Broil or Self Clean temperatures.
The oven temperature adjustment may be made
if your oven control is set to display temperatures
in °C (Celsius). Minimum and maximum settings
for Celsius range from plus (+)19°C to minus (-)
19°C.
Restoring factory Default Settings
Your appliance was set with predetermined
(default) oven control settings. Over time, users may
have made changes to these settings. The following
options may have been modified since the appliance
was new:
12 or 24 hr display mode
Continuous bake or 12 hour energy savings
mode
Silent or audible control
Oven temperature display
(Fahrenheit or Celsius)
Oven temperature adjustments (UPO)
CaUTION
ALL of the above user settings will be restored to
the factory default settings.
To restore oven control to factory default
settings:
Press and hold 7 on numeric keypad until acceptance
tone sounds (about 6 seconds).
Press OK/STaRT. The control has been reset with
the default settings.
OVEN CONTROLS
37

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

404.660.06

Table of Contents