Setting Surface Controls - IKEA TVÄRSÄKER Manual

EN
Cooktop Display Windows
The range backguard provides a digital window for
each of the cooking zones located on the cooktop.
Power levels and messages are easily monitored and
controlled using the window displays in combination
with the corresponding controls.
available power Level Settings
The cooktop control will display power levels rang-
ing from p, Hi to Lo. The settings between 9 and 2
decrease and increase in 1.0 increments.
The lowest setting L will display just below 2.
power Boost power Level (p)
When setting an induction cooking zone for the high-
est setting (to the POWER BOOST position), the dis-
play will initially show p (Power Boost) power level
for up to 10 minutes. After 10 minutes, the power
boost cooking zone will automatically return to the
high H setting. The P setting is only available imme-
diately after activating a cooking zone.
ESEC Error Indicator Message (E)
An error message will be displayed (flashing E)
at power up (or after a power failure) if any of the
surface settings were left in the ON positions. If a
power failure should occur, set all of the four surface
controls to the OFF position. This will reset the sur-
face controls.
Be sure to reset the clock. Once the surface controls
have been set to the OFF positions and the clock has
been set with the correct time of day, the surface
controls should return to normal operation. If the
surface controls do not function and the error mes-
sage remains in any display after following these
procedures, contact an authorized servicer for assis-
tance.

SETTING SURfaCE CONTROLS

SETTING SURfaCE CONTROLS
Lockout Window Message (-)
The (-) message will appear in all the surface control
displays whenever the Lockout or Self-clean feature
is active.
power Boost
Low setting
Error message
Cooktop Lockout
High setting
Highest number
setting
Simmer setting
17