Connecting The Dlan 200 Avdesk - Devolo 200 AVdesk User Manual

Make sure that all of the dLAN 200 AV devices that you want to add to your net-
work are also connected to the power supply grid. After about 20 minutes, a
dLAN 200 AVdesk switches into stand-by mode unless there is an active device
(e. g. computer) connected to the Ethernet interface. dLAN 200 AV devices in
stand-by mode are not accessible over the power supply grid. As soon as device
(e.g. computer) connected to the Ethernet interface is switched on again, your
dLAN 200 AVdesk can also be reached again via the electric supply.
2.3 Connecting the
In this section, we will show you how to connect the dLAN 200 AVdesk to a
computer.
No drivers are required for running the dLAN 200 AVdesk.
ETH 10/Act
Col
ETH
AC
Use the included power cable to connect the dLAN 200 AVdesk to a power
outlet.
With the computer running use the included network cable to connect the
dLAN 200 AVdesk to an Ethernet port of the computer.
Continue with the installation of the devolo dLAN 200 AV software. For
more information, refer to the chapter on 'devolo dLAN 200 AV software'.
|
Is lit whenever an Ethernet connection of 10 Mbps
exists; flashes when data are being sent or received.
Flashes at a faster rate if the network is experiencing
increasing use.
This is the connection point on the dLAN 200 AVdesk
for connecting it to a computer or another device with
the network cable (included).
Here you connect the dLAN 200 AVdesk to the power
supply using the supplied power cable.
dLAN 200 AVdesk
Connection and startup
|
devolo dLAN 200 AVdesk
9
|