Integrated Electrical Socket; Standby Mode; Connecting The Dlan Pro 1200+ Triple - Devolo dLAN pro 1200+ triple Manual

16 Installation
devolo dLAN pro 1200+ triple
please see the chapter 4.2 dLAN pro network en-
cryption at the touch of a button.
For safety reasons, you can deacti-
vate the encryption button in the
dLAN AVpro manager software.

3.3.4 Integrated electrical socket

If you connect additional network devices using a mul-
tiple socket, plug this multiple socket into the electrical
socket of the dLAN pro 1200+ triple. The integrated
mains filter eliminates any noise of connected devices
and significantly improves data transmission in the
home network.

3.3.5 Standby mode

A dLAN pro device switches to Standby mode after a
short while if no active network device such as a com-
puter is connected to the network port. In Standby
mode, the dLAN pro device cannot be accessed
via the power supply grid. As soon as the network
device (e.g. computer) connected to the network inter-
face is switched on again, your dLAN pro device can
also be reached again via the electrical wiring.
The energy-saving mode is disabled for the
dLAN pro 1200+ triple in the factory defaults.
If you would like to ensure that a dLAN device switches
to energy saving mode, this function can be activated
in the dLAN AVpro manager software. More informa-
tion concerning "energy-saving mode" can be found in
the chapter 2.1 devolo—Up to speed on green IT.
3.4 Connecting the
dLAN pro 1200+ triple
This section describes how to connect your
dLAN pro 1200+ triple to computers or other network
devices.
For the permitted voltage range for
operating the device and the power
consumption, refer to the label on
the rear side
Additional technical information is
available in the download area at
www.devolo.com.
The device is designed for indoor use
only.
Use network cables
dLAN pro 1200+ triple to the network ports of
your running computers or other network devices.
of the device.
to connect the