Disassembling the Handle Assembly (continued)
Assembling the Handle Assembly
Greensmaster
®
eFlex 1021
20248SL Rev A
29. Remove the flange nut (8) and bolt (2) that secure the clutch bail assembly
(4) to the handle mount (7). Remove the clutch bail assembly from the
handle mount. Remove the compression spring (6), 2 flange bushings (3)
and spacer tube (13) from the handle mount.
30. Remove the 2 nuts (9) and 2 bolts (11) that secures the handle mount (7)
to the upper receiver weldment (15). Remove the handle mount from the
upper receiver weldment.
g337210
1.
Lower handle assembly
2.
Bolt
3.
Washer (2 each)
31. If necessary, remove the nut (item 4 in
that secures the lower handle assembly (1) to the frame assembly (5).
1. If removed, install the lower handle assembly (item 1 in
frame assembly (5) and secure with the bolt (2), washers (3) and nut (4).
2. Lift the lower handle assembly to maximum top position and torque tighten
the bolt (2) to 5.6 to 6.2 N·m (50 to 55 ft-lb).
3. Install the handle mount (item 7 in
(10) and secure with 2 bolts (11) and 2 nuts (9).
4. Position the clutch bail link (5) in the handle mount (7). Install the spacer tube
(13) and 2 flange bushings (3) to the handle mount. Secure the clutch bail
link to the handle mount with the bolt (2) and flange nut (8).
Figure 87
4.
Nut
5.
Frame assembly
Figure
Figure
86) to the upper receiver weldment
Page 6–17
Controls, Wheels and Accessories : Service and Repairs
87), washers (3) and bolt (2)
Figure
87) onto the