Drawbar; Adjusting The Drawbar Length; Swing Drawbar - Kubota L4701 Operator's Manual

3-POINT HITCH AND DRAWBAR
2. After aligning satisfactorily, insert the set-pin
through any one of the 4 holes on the outer tube
that align with one of the holes on the inner bar.
Both stabilizers will be locked.
If the set-pin is inserted through the slot to engage
one of the holes on the inner bar, a limited degree
of sway will be permitted.
(1) Outer tube
(2) Inner bar
(3) Set-pin

DRAWBAR

WARNING
To avoid personal injury or death:
• Never pull from the top link, the rear axle, or any
point above the drawbar. Pulling from the top
link, the rear axle, or any point above the
drawbar could cause the tractor to tip over
rearward.

1. Adjusting the drawbar length

1. Adjust the length of the drawbar.
When towing an implement, it is recommended that
the (B) hole in drawbar to be utilized.
For information about the drawbar load, read the
IMPLEMENT LIMITATION TABLES on page 24.
76
(4) Hole
(5) Slot
(1) PTO shaft
(2) Drawbar
(3) Pivot pin

2. Swing drawbar

You can use the swing drawbar in 3 different ways as
follows. Assemble the swing drawbar correctly with set
of joint pins at the points as marked by
[A] Using way-A
[B] Using way-B
[C] Using way-C
DRAWBAR
(A) Hole-A
(B) Hole-B
in the figure.
(A) Hole-A
(B) 140 mm (5.5 in.)
L4701