Cadel NICE Installation, Use And Maintenance Handbook page 85

PROBLEM
Door not closing
Stove goes off
Alarm on display
"AlAr dEp"
Clogged outlet
Fumes extractor broken down
Hose holder attachment clogged
Faulty pressure switch
Faulty electronic circuit board
Chimney too long
Bad weather conditions
Boiler overheating
Room heat exchanger fan not
working
Temporary power failure
Faulty thermostat
Faulty fumes probe
Stove goes off
Alarm on display
"AlAr HottEmp"
Faulty electronic circuit board
Room heat exchanger fan not
working
Circuit board setting at stage 5 too
high
MIRIAM-NICE-DIANA-PRETTY-MARY
CAUSE SOLUTION
Close door properly and check state of gaskets;
replace if necessary.
Exhaust pipe partly or completely clogged
(check with an expert what's necessary from
the stove outlet up to the chimney).
Clean immediately.
Pellets burn also due to the draught in the flue
without the aid of an extraction device.
Replace fumes extractor immediately: stoves
operating without a fumes extractor may be a
health hazard. Call an expert.
Detach silicone pipe from hose holder and use
a pointed metal tool to clean hose holder hole.
Replace silicone pipe if necessary.
Replace pressure switch.
Call an expert.
Replace electronic circuit board.
Call an expert.
Have an expert check that the exhaust pipe
complies with standards (see
65 and following).
Strong winds may cause negative pressure in
the chimney. Check and re-start stove.
Let stove cool; thermostat
automatically. If problem persists call an
expert.
Replace room fan.
Call expert.
A black-out when the stove is in operation
causes the boiler to overheat and the
thermostat to cut in. Let stove cool then re-
start.
Replace 60° NC thermostat.
Call expert.
Replace fumes probe.
Call an expert.
Replace electronic circuit board.
Call an expert.
Replace room fan.
Call an expert.
Have an expert regulate pellet loading.
chapter
2, page
will re-start
Pag. 85