3-4. Installing the thread stand
❷
❷
❻
❻
❶
❶
❸
❸
❺
❺
❹
❹
1) Take out thread stand device from the electrical
equipment shelf. Install the spool support (asm)
❷ onto thread stand bar (lower) ❶ that has been
mounted to the table as shown in the figure.
2) Attach collar with tapped hole ❸ to thread stand
bar (lower) ❶ .
3) Put thread stand arm (asm.) ❺ and thread stand
thread guide ❻ over thread stand bar (upper) ❹ ,
and install thread stand bar (upper) ❹ to collar ❸
as shown in the figure.
Then, put thread stands into the holes in the
thread stand bars (upper and lower) and tighten
them with a thin screwdriver.
– 7 –