Table of Contents
Advertisement
Classifi-
cation of
No.
Parameter name
parameters
Energi-
P73
Presser foot is lifted at the
zation
time of turning the power
ON
setting
Other
P74
Whether or not the air pres-
sure detection is required
settings
P75
Whether or not the repeti-
tive operation is required
Repetitive machining time
P76
(min)
Repetitive machining inter-
P77
val (s)
P78
Work ending position
P395
Template recognition meth-
od
P81
Interface style
P681
Motion mode is started
before operation
P755
Jump mode during opera-
tion
Connection to the extend-
P241
ed screen
Reverse feed after main
P79
shaft needle stops
P242
Voice prompt
P21
Enabling the memory func-
tion during power failure
P194
File is enabled when the
electronic tag separates
from it
Standard
Range
value
Yes/No
No
Yes/No
Yes
Yes/No
Yes
1 to 65535
1440
0 to 20
0
Return to 0
Return to
(zero) / sewing
0 (zero)
starting position
/ default
Barcode / elec-
Electronic
tronic tag
tag
Classic / simple Classic
XY simul-
XY simul-
taneous / X
taneous
precedence / Y
precedence
X precedence /
XY simul-
Y precedence /
taneous
XY simultane-
ous
Yes/No
No
0 to 160
50
High / medium /
OFF
low / OFF
Enable / disable Enable
Enable / disable Disable
– 42 –
Meaning of parameter and comment
Presser foot goes up when turning the
power ON
In the case of "Yes", the sewing ma-
chine stops and generates the alarm if
the detected air pressure is low during
work
"Yes" means that cyclic machining of
the same file is started after turning the
power ON
Cyclic machining total time: When the
set time has elapsed, cyclic machining
is stopped
Interval from the completion of machin-
ing to re-starting of machining under
the cyclic machining mode
Return to 0 (zero): All of x / y axes
coordinates return to 0 (zero); sewing
machine terminates sewing; reset point
Right side: Rightmost position within
the machining range
Sewing starting position: First sewing
point of the machining file
Default: The sewing machine stops
after the completion of machining
By serial number of file: Barcode identi-
fication mode
By file name: Electronic tag identifica-
tion mode
Classic: Button style of the virtual body
Simple: Flat button style
Jump travel mode
In the case of "Yes", information on the
operation file can be displayed on the
external add-on display
"High", "medium" and "low" respective-
ly refer to the magnitude of sound
After re-energization of the sewing
machine, the sewing sequence carried
out before power failure is resumed to
continue sewing from that interrupted
sequence.
Advertisement
Table of Contents
