Adjusting The Needle Thread Air Blower - JUKI PS-800-6045 Instruction Manual

4-17. Adjusting the needle thread air blower

❶ ❶
Launch the pattern creation software to operate and process the pattern to be sewn.
On the screen that is displayed by clicking "Operation processing" ❸ , click ❹ ("Enter I/O") and change the
"I/O" to 5.
Change the "Level" to "high" ("low" refers to "turning OFF"). Click ❺ ("Delay"). Change the "Delay (msec)" to
225.
The needle thread air blower and the wiper cannot be used simultaneously.
1. The wiper provides the function for bringing the needle thread above the presser foot.
2. The needle thread air blower provides the function for bringing the needle thread under the
disk presser.
Blow-up pipe ❶ blows air to blow up the thread end
trailing from the needle to bring it under disk presser
❷ at the beginning of sewing by controlling the sole-
❷ ❷
noid valve of the electrical system.
Thread end is pushed by air between the disk press-
er and the pattern at the beginning of sewing. In the
case the thread end cannot be pushed due to the lo-
cation and direction of slits on the pattern, adjust the
blowing direction of the air to allow the thread end to
be pushed by air.
❸
❹
– 29 –
❺