Table of Contents
Advertisement
Classifi-
cation of
No.
Parameter name
parameters
Reset
Clamp at the time of reset-
P36
ting
setting
Clamp is opened after
P264
manual resetting
Return-to-origin method
P38
Return-to-origin speed
P39
(mm/min)
P756-
Output I/O setting before
resetting
P761
P762-
P797
P649
Alarm in the case of a
resetting error
P782-
Output IO setting after
P787
resetting
P788-
P793
Tempo-
P40
Automatic thread trimming
during the temporary stop
rary stop
setting
P41
Needle position during the
temporary stop
P45
Type of the temporary stop
switch
P799
The presser foot does not
go up during the temporary
stop
Statistics
P49
Bobbin thread remaining
amount is cleared at the
settings
time of turning the power
ON
P50
Operation stops after the
bobbin thread has run out
P51
Bobbin thread counter
setting is enabled
P46
Bobbin thread counter is
cleared at the time of turn-
ing the power ON
Standard
Range
value
Yes/No
No
Yes/No
Yes
XY simul-
XY simul-
taneous / X
taneous
preference / Y
preference
100 to 60000
15000
OUT1 to OUT6
Not set
/ Not set
High level / Low
High level
level
Yes/No
No
OUT1 to OUT6
Not set
/ Not set
High level / Low
Low level
level
Yes/No
No
Upper stop
Upper
position / Lower
stop posi-
stop position
tion
Self lock / Nor-
Self lock
mal
Yes/No
No
Yes/No
No
Yes/No
No
Yes/No
No
Yes/No
No
– 40 –
Meaning of parameter and comment
Cassette clamp comes down when
returning to origin
Cassette clamp goes up when returning
to origin by pressing the reset button
"XY simultaneous" means that both the
X and Y axes simultaneously start the
"return to origin" operation. "X priority"
means that the X axis returns to its
origin first, then the Y axis returns to its
origin.
X, Y axes speed during resetting to the
origin
Setting of IO before resetting
Setting of IO after returning to the origin
"Yes" : Thread is automatically trimmed
"No" : Thread is not trimmed
In the case the temporary stop switch
type is "Self lock", the temporary stop
function does not automatically oper-
ate when the switch is pressed.
In the case the temporary stop switch
type is "Normal", the temporary stop
function automatically operates when
the switch is pressed.
Whether the remaining amount of
bobbin thread is reset to 0 (zero) when
turning the power ON
In the case of "Yes", the sewing ma-
chine stops when the consumed bobbin
thread length has reached the "entire
length".
In the case of "Yes", statistics automat-
ically indicate the consumed bobbin
thread length
Whether the sewing counter is reset to
0 (zero) when turning the power ON
Advertisement
Table of Contents
