Table of Contents
Advertisement
Error
Error description
Code
E242 No work IO
E243 Waiting for input IO
E244 Execution delay
E245 The file name is too long
E246 Please lift the presser foot
first
E247 Frame is not pressed down
E248 Auxiliary frame is not
pressed down
E249 Frame and auxiliary frame
is not pressed down
E250 Punched material has run
out
E251 Reset failed
E252 Rotating motor failure
E400 Drive board cannot be con-
nected
E401 (0x) Drive board hardware
protection
Fault Cause
1. The work enable input IO signal is
abnormal.
2. Parameter setting error
1. Input IO signal in waiting file
2. Corresponding input IO sensor
has bad contact or is damaged or
unable to trigger
3. Parameter or file setting error
1. Execute the delay instruction in
the graphics file
2. The delay time is too long
The file name written in the electron-
ic tag is longer than 32 bytes (32
English or 16 Chinese characters)
Presser foot not raised
Unpressed frame
1. Unpressed auxiliary pressure
frame
2. Parameter setting error
1. Unpressed frame and auxiliary
frame
2. Parameter setting error
Out of punching base material
The reset fails due to various rea-
sons, such as the origin cannot be
found during reset
1. Rotary motor alarm due to me-
chanical overload, etc.
2. The motor wire of the rotating mo-
tor is disconnected, the interface
is loose, and the connection line
between the motor and the driver
is faulty.
3.Rotary shaft driver is broken
4.The rotating motor is broken
Abnormal circuit of main board
1. The motor is broken or the motor
wire is damaged and short circuit-
ed
2. The motor is stuck
3. The driver board is damaged
4. The parameters are incorrect
– 54 –
Solution
1. Check the corresponding IO
2. Turn off the "work enable input IO" func-
tion and set the parameter value to 0
1. Automatically disappears when the
corresponding IO is detected
2. Check sensor failure
3. Resetting parameters or processing
files
1. It disappears automatically after com-
pleting the delay
2. Reset delay as appropriate
Need to shorten the length of the file name
before writing
Click the "Presser Foot" button to raise the
presser foot
Click the "press frame" button to lower the
frame
1. Click the corresponding IO button of the
auxiliary pressure frame
2. Reset parameters
1. Click the corresponding button to push
down both the pressing frame and the
auxiliary pressing frame.
2. Reset parameters
Need to replace the new punch base ma-
terial
Go to "Auxiliary Settings" - "Test Transmis-
sion" - "Alarm Log" to see which alarms
have occurred during this reset failure.
Refer to the previous alarm faults to re-
solve these alarms and reset them.
1. Check if the machine is stuck
2.Chec k the corresponding wiring
3.Replace the flashing drive
4.Replace the motor
Overhaul the motherboard circuit
1. Check and replace the motor
2. Check the machinery
3. Replace the Y servo board
4. Reset or redirect parameters
Advertisement
Table of Contents
