Table of Contents
Advertisement
Classifi-
cation of
No.
Parameter name
parameters
Statistics
P47
Operation continues after
settings
the counter has reached
the set value
Counter setting is enabled
P48
P52
Working hours counter
P779
Bobbin thread count mode
P780
Adjustment value of the
surplus amount of bobbin
thread (mm)
Thread
P54
Thread clamp position at
the beginning of sewing
clamp
setting
P236
Laser output IO
Detection
P55
Automatic detection of
thread breakage
of thread
breakage
P57
Detection is ignored for
the set number of stitches
during sewing
Detection of the effective
P58
number of stitches in the
case of thread breakage
P237
Thread breakage output IO Out 1 to OUT12
Thread
P60
The number of revolutions
of the thread trimmer main
breakage
shaft (r/min)
setting
P61
Delay in the start of thread
trimmer (s)
Continuous operating time
P62
of the wiper (s)
P63
Delay in the lifting of press-
er foot after turning OFF
the wiper (s)
P65
Whether or not the thread
is trimmed during jump
after sewing
P66
Whether or not the wiper is
used
P169
Thread slackening start
mode
P168
Thread slackening angle
Energi-
P70
The sewing machine is re-
turned to the "stop with its
zation
needle up" state at the time
setting
of turning the power ON
Clamp is automatically
P71
returned to its origin at the
time of turning the power
ON
Standard
Range
value
Yes/No
v
Yes/No
No
Yes/No
No
IN1 to IN4 /
Default
default
0 to 600000
0
0 to 200
0
Out 1 to OUT12
No
/No
Yes/No
No
1 to 255
5
1 to 255
15
No
/No
10 to 500
180
0.01 to 6.55
0.01
0.01 to 6.55
0.15
0.01 to 6.55
0.25
Yes/No
Yes
Yes/No
Yes
Angle / delay
Angle
0 to 999
730
Yes/No
No
Yes/No
No
– 41 –
Meaning of parameter and comment
Whether the operation is continued
after the sewing counter has reached
the set value
Whether the sewing counter is enabled
In the case of "Yes", the machining time
statistics function is enabled
Statics mode of the bobbin thread
amount
Adjustment of the bobbin thread re-
maining amount
Thread clamp position at the beginning
of sewing
Laser output
In the case of "Yes", the operation is
stopped and the description of error is
displayed.
Thread breakage detection function
For the number of stitches firstly set,
thread breakage will not be detected
In the case thread breakage is detect-
ed continuously to reach the specified
maximum number of broken stitches,
it is assumed that thread has broken
definitely.
Thread trimmer main shaft speed
Delay time at the start of thread trim-
ming
Wiper operating time
Wiper OFF delay time
Whether thread is trimmed at the time
of jump
Whether the wiper is used
Starting timing method for turning OFF
the thread tension release mechanism
Thread tension release mechanism
turning-OFF angle
Needle bar is at upper position when
turning the power ON
Cassette automatically returns to its
origin when turning the power ON
Advertisement
Table of Contents
