Video Connector; Figure B-6. Pin Numbers For The Video Connector; Table B-4. Pin Assignments For The Mouse Connector; Table B-5. Pin Assignments For The Video Connector - Dell 6100 User Manual

Table B-4. Pin Assignments for the Mouse
Connector
Pin Signal
1 MSEDATA
2 NC
3 GND
4 FUSED_VCC
(+5 V)
5 MSECLK
6 NC
V
ideo Connector
The system uses a 15-pin high-density D-subminiature
connector on the back panel for attaching a video graph-
ics array (VGA)-compatible monitor to your computer.
The video circuitry on the system board synchronizes the
signals that drive the red, green, and blue electron guns in
the monitor.
NOTE: Installing a video card automatically disables the
system's built-in video subsystem.
If you reconfigure your hardware, you may need pin
number and signal information for the video connector.
Figure B-6 illustrates the pin numbers for the video
connector, and Table B-5 lists and defines the pin assign-
ments and interface signals for the video connector.
I/O Definition
I/O Mouse data
N/A No connection
N/A Signal ground
N/A Fused supply voltage
I/O Mouse clock
N/A No connection
Figure B-6. Pin Numbers for the Video
Connector
Table B-5. Pin Assignments for the Video
Connector
Pin Signal
1 RED
2 GREEN
3 BLUE
4 NC
5-8, 10 GND
9 DDC
11 NC
12 DDC
data out
13 HSYNC
14 VSYNC
15 DDC
clock out
Shell N/A
I/O Ports and Connectors
I/O Definition
O Red video
O Green video
O Blue video
N/A No connection
N/A Signal ground
N/A Vcc
N/A No connection
O Monitor detect data
O Horizontal synchro-
nization
O Vertical synchroniza-
tion
O Monitor detect clock
N/A Chassis ground
B-5