Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Fanco Infinity-ID DC CFFCINID2LWHSMR
Summary of Contents for Fanco Infinity-ID DC CFFCINID2LWHSMR
- Page 1 Infinity-ID Installation Manual...
-
Page 2: Important Safeguards
Ceiling fan instruction booklet Thank you for purchasing your Fanco Infinity-ID DC Ceiling Fan. Please read all instructions carefully before assembly and use. IMPORTANT SAFEGUARDS Read all instructions carefully, even if you feel you are quite familiar with this type of appliance. -
Page 3: Important Note
19. If it is necessary to replace the live or neutral brushes to ensure operation of the motor then both brushes and the earth brush shall be replaced at the same time. The brushes shall only be replaced by a suitably qualified person. 20. -
Page 4: Parts Included
PARTS INCLUDED Hanging Bracket Receiver Canopy Decorative Ring Downrod with Ball Joint Motor Housing Coupler Blade Buckle Blade Light Kit (with Light Models ONLY) Remote or Wall Control... -
Page 5: Installation And Assembly
INSTALLATION AND ASSEMBLY CAUTION: Before installing the fan make sure you have turned OFF the electricity supply. SELECTING A LOCATION: 1. Choose a location for mounting the fan where the blades will have at least 2.1 metres of clearance from the floor. 2. -
Page 9: Installation Steps
INSTALLATION STEPS 1. Lift up the motor housing, Take the pre assembled screws and blade buckles off the motor. Align the blades with screw holes on top of the motor and secure with the blade buckles, screws and washers. - Page 10 2. Once all blades are securely attached to the motor, simply slide the motor housing down into place. 3. For models with light - Remove the three screws on the middle of the motor, Align the light kit with the screw holes on the motor housing and secure with screws. Connect the push plug wire attached on the light kit with the push plug attached to the motor.
- Page 11 4. Carefully lift the assembled fan and 5. Place the receiver within the hanging place the hanging ball in the middle of the bracket and connect the wires. hanging bracket. Place the hanging ball into the bracket. 6. Connect power, receiver and the fan in accordance with the electrical wiring diagram. IMPORTANT: The fan must be earthed! Double pole disconnection switch and wall switch must be connected.
- Page 12 CARE & CLEANING: • Periodic cleaning (approximately 6 months) of your ceiling fan is the only maintenance required. • Use a soft brush or lint free cloth to avoid scratching the finish. Please turn off electricity when you do so. •...
-
Page 13: Functions Of The Transmitter
as remote controlled items operating on the same frequency may disturb each other. 2. If the battery is low it will affect the sensitivity of the remote control and the signal reception and must be replaced (the LED indicator light will flash a warning when the battery runs low). 3. - Page 14 Trouble Possible Cause Suggested Remedy Fans does not start after A) Remote and receiver are A) Re-pair the receiver and pairing process not paired successfully remote B) Battery flat in remote B) Replace the battery in control remote control C) Loose wire connections C) Check wire connections or plugs to fan/receiver and ensure plugs are...
- Page 15 Model Number Rated Voltage Motor Consumption Rated Light Power Control CFFCINID2LWHSMR 220-240 Vac Max. 35 W Max. 18 W Remote CFFCINID2WHSMR 220-240 Vac Max. 35 W Remote CFFCINID2WHW 220-240 Vac Max. 35 W Wall Control CFFCINID4BLSMR 220-240 Vac Max. 35 W Remote CFFCINID4BLW 220-240 Vac...