Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Fanco Eco Silent Deluxe DC
Summary of Contents for Fanco Eco Silent Deluxe DC
- Page 1 Eco Silent Deluxe Installation Manual...
-
Page 2: Important Safeguards
Ceiling fan instruction booklet Thank you for purchasing your Fanco Eco Silent Deluxe DC Ceiling Fan. Please read all instructions carefully before assembly and use. IMPORTANT SAFEGUARDS Read all instructions carefully, even if you feel you are quite familiar with this type of appliance. -
Page 3: Important Note
19. If it is necessary to replace the live or neutral brushes to ensure operation of the motor then both brushes and the earth brush shall be replaced at the same time. The brushes shall only be replaced by a suitably qualified person. 20. -
Page 4: Parts Included
PARTS INCLUDED Hanging Bracket Receiver Canopy Remote or Wall Control Downrod with Ball Joint Cotter Pin & Cross Pin Blade Motor Light Kit (with Light Models ONLY) No Light Cap INSTALLATION AND ASSEMBLY CAUTION: Before installing the fan make sure you have turned OFF the electricity supply. SELECTING A LOCATION: 1. -
Page 8: Installation Steps
INSTALLATION STEPS 1. For model with light - Remove the screws that fix the light kit and put the light and screws aside. - Page 9 2. Remove the screws & washers from the bottom of the motor housing. Insert the blades through the slots in the motor, Align the blades with screw holes in the motor housing and secure them with the screws and washers. 3.
- Page 10 4. For models with light - Attach the light kit back on to the motor with the screws that were removed in step 1. Line the diffuser up with the bottom of the motor and rotate clockwise until it locks securely into place. 5.
- Page 11 6. Place hanging ball into the hanging bracket as pictured below. 7. Place the receiver above the hanging ball and connect the wires. 8. Connect power, receiver and the fan in accordance with the electrical wiring diagram. IMPORTANT: The fan must be earthed! Double pole disconnection switch and wall switch must be connected.
- Page 12 PAIRING THE REMOTE: All Eco Silent Deluxe DC fans are pre-paired and there is no paring process needed to start the fan. If you want to reset the fan to factory setting. Please follow steps below.
-
Page 13: Functions Of The Transmitter
b. Please check if there are any other similarly remote controlled objects that work nearby, as remote controlled items operating on the same frequency may disturb each other. 2. If the battery is low it will affect the sensitivity of the remote control and the signal reception and must be replaced (the LED indicator light will flash a warning when the battery runs low). - Page 14 Trouble Possible Cause Suggested Remedy Fans does not start after A) Remote and receiver are A) Re-pair the receiver and pairing process not paired successfully remote B) Battery flat in remote B) Replace the battery in control remote control C) Loose wire connections C) Check wire connections or plugs to fan/receiver and ensure plugs are...
- Page 15 Model Number Rated Voltage Motor Consumption Rated Light Power Control CFFCESD3WHWABS 220-240 Vac Max. 45 W Wall Control CFFCESD3WHSMRABS 220-240 Vac Max. 45 W Remote CFFCESD3LWHSMRABS 220-240 Vac Max. 45 W Max. 18 W Remote CFFCESD3BLWABS 220-240 Vac Max. 45 W Wall Control CFFCESD3BLSMRABS 220-240 Vac...