Boot; Save & Exit - DFI WL051 User Manual

X Boot
Setup Prompt Timeout
Set the number of seconds to wait for the setup activation key. 65535 (0xFFFF) denotes
indefinite waiting.
Bootup NumLock State
Select the keyboard NumLock state: On or Off.
Quiet Boot
This section is used to enable or disable quiet boot option.
Boot Option Priorities
Rearrange the system boot order of available boot devices.
BGRT Logo
It is used to enable or disable to support display logo with ACPI BGRT table.
Note:
If "Boot option filter" of "CSM Configuration" is set to "UEFI and Legacy"
or "UEFI only" and "Quiet Boot" is set to enabled, "BGRT Logo" will show
up for configuration. Refer to the Advanced > CSM Configuration for more
information.
User's Manual | WL051
X Save & Exit
Save Changes and Reset
To save the changes, select this field and then press <Enter>. A dialog box will appear. Select
Yes to reset the system after saving all changes made.
Discard Changes and Reset
To discard the changes, select this field and then press <Enter>. A dialog box will appear.
Select Yes to reset the system setup without saving any changes.
Restore Defaults
To restore and load the optimized default values, select this field and then press <Enter>. A
dialog box will appear. Select Yes to restore the default values of all the setup options.
Boot Override
Move the cursor to an available boot device and press Enter, and then the system will
immediately boot from the selected boot device. The Boot Override function will only be
effective for the current boot. The "Boot Option Priorities" configured in the Boot menu will not
be changed.
► Save Setting to file
Select this option to save BIOS configuration settings to a USB flash device.
► Restore Setting from file
This field will appear only when a USB flash device is detected. Select this field to restore
setting from the USB flash device.
Chapter 3
BIOS SETTINGS
38