Silvercrest SED 3.7 D2 Operating Instructions Manual page 14

NOTICE
► It may be that the hair grows back after a few days. The
reason for this is that these hairs were too short to be
removed during the last epilation session.
6) When you are finished with the treatment, place the speed switch
to "0".
7) Clean the epilator head
and Care".
8) Replace the protective cap
NOTICE
► If the epilator head
To order a new epilator head
partment (see chapter "Guarantee and service"). Please have
the IAN number ready (see operating manual cover).
To replace the epilator head
― Press the two restraint fixtures
same time pull the epilator head
― Press the new epilator head
Ensure that the gears on the epilator head
the appliance mesh with each other. The epilator head
must audibly engage.
SED 3.7 D2
as described in the section "Cleaning
on the epilator head
is damaged, discontinue all further use!
, please contact the service de-
, please proceed as follows:
.
together and at the
upwards.
onto the appliance.
and on
GB
11