Dell Latitude D630 User Manual page 129

1 screws (2) 2 hard drive
NOTE:
The number of hard drive screws may vary.
2 Remove the hard drive screws on the bottom of the computer.
NOTICE:
When the hard drive is not in the computer, store it in protective antistatic packaging. See "Protecting
Against Electrostatic Discharge" in the Product Information Guide.
3 Slide the hard drive out of the computer.
4 Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
NOTICE:
Use firm and even pressure to slide the drive into place. If you use excessive force, you may damage the
connector.
5 Slide the hard drive into the bay until it is fully seated.
6 Replace and tighten the screws.
7 Use the Operating System media to install the operating system for your computer (see "Using the
Operating System Media" on page 106).
8 Use the Drivers and Utilities media to install the drivers and utilities for your computer (see
"Reinstalling Drivers and Utilities" on page 102).
1
2
Adding and Replacing Parts
127