Troubleshooting Instructions - Ecoflam MAIOR P 700.1 PRE Manual

TROUBLESHOOTING INSTRUCTIONS

For Setting and Error Lists refer to LAMTEC manual attacched.
OPERATING TROUBLE
In case of operating trouble it should be
checked whether the system is in proper
working order.
Make a check for the following:
1. Availability of fuel.
Availability of gas in the line at sufficiently
high pressure.
Availability of fuel oil in the tank (for dual
fuel burner).
Correct position of fuel selector switch.
2. Availability of electric power in the
burner system.
APPENDIX
Control box ­ Display
1 2
!
Always switch off the power supply before installing or removing the control unit.
Do not attempt to open or carry out repairs on the control unit.
Refer to LAMTEC manual attacched.
420010985900
3. Proper functional order and setting of all
control and safety instruments such as
temperature controller, safety limiter, water
failure cut-out, electrical limit switches, etc.
If the trouble is not found to be due to any
of the above-mentioned points it will be
necessary to test the burner functions very
carefully.
Prevailing conditions:
The burner will be found to be out of
operation and in faulty and interlocked
position.
1 Display
2 Back key
3 4
3 Cursor keys
4 Enter key
Display
The display shows in pictogram:
• the menu structure
• operating status
• parameters
• error messages
Proceed with searching for the cause of
the trouble and eliminate it. Unlock the
control box by pressing the fault eliminate
key and start the burner.
Do not press the fault eliminate key longer
than 10 seconds.
The start-up program will be initiated and
should be carefully monitored.
The possible cause of the fault may be
quickly found by reference to the fault
indicator of the control box and watching
the start-up and operating program.
Jump to previous window.
You navigate in the menu using
cursor keys. You use 'left' and 'right'
keys to move step by step in a
selected row. At the end of the
selected row the cursor jumps
down to the next row, if possible.In
a multiline menu use 'up' and
'down' keys to switch to other
rows.To display parameters, switch
between various fields.
Press ENTER to call up a menu on
the start screen. Select a sub-menu
in the menu window. Transfer
setting values by pressing ENTER
key in a parameter window.Use a
flushing, red ENTER key to release
a fault interlocker.If the ENTER key
is permanently lit red, a fault with
an automatic restart is displayed.
www.ecoflam­burners.com
EN
21