Removing Dimms - Dell OptiPlex GX50 User Manual

The amount of system memory has changed.
Strike the F1 key to continue, F2 to run the setup
utility
Press <F2> to enter system setup, and check the value for System
5
Memory.
The computer should have already changed the value of System
Memory to reflect the newly installed memory. Verify the new total. If
it is correct, skip to step 7.
If the memory total is incorrect, turn off and disconnect your
6
computer and devices from their electrical outlets.
cover, and check the installed DIMMs to make sure that they are
seated properly in their sockets. Then repeat steps 3, 4, and 5.
Reset the chassis intrusion detector
7
Enabled or Enabled-Silent.
NOTE: If a setup password has been assigned by someone else, contact
your network administrator for information on resetting the chassis
intrusion detector.
When the System Memory total is correct, press <Esc> to exit system
8
setup.
Run the Dell Diagnostics
9
properly.

Removing DIMMs

To remove a DIMM, press the securing clips outward simultaneously until
the DIMM disengages and pops out slightly from the socket.
NOTICE: To avoid damage to the memory module, press the securing clips
with equal force applied at each end of the socket.
Open the computer
by changing Chassis Intrusion to
to verify that the DIMMs are operating
In s ta l l i n g U p gr a d e s
79