Dell Dimension 9200 Owner's Manual page 99

NOTICE:
Ensure that you release the securing tab to unseat the card. If the card is not removed correctly, the
system board may be damaged.
6 Release the securing tab on the card slot to unseat the card.
7 If you are removing the card permanently, install a filler bracket in the empty card-slot opening.
If you need a filler bracket, contact Dell (see "Contacting Dell" on page 137).
NOTE:
Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the
computer. The brackets also keep dust and dirt out of your computer.
8 Reseat the card retention mechanism in the tabs and pivot downward to snap it into place.
9 Close the card retention door to snap it into place, securing the card(s).
NOTE:
For full-length PCI-E cards, if a "piano" bracket is present on your computer you need to rotate it down into
place.
NOTICE:
To connect a network cable, first plug the cable into the network device and then plug the cable into the
computer.
10 Replace the computer cover, reconnect the computer and devices to electrical outlets, and then turn
them on.
11 Remove the card driver from the operating system.
12 If you removed a sound card:
Enter system setup, select Integrated Audio Controller, and then change the setting to On.
a
Connect external audio devices to the integrated audio connectors on the back panel of the
b
computer.
13 If you removed an add-in network connector:
Enter system setup, select Integrated NIC Controller, and then change the setting to On.
a
Connect the network cable to the integrated connector on the back panel of the computer.
b
NOTE:
any drivers required for the card as described in the card documentation.
Install
Removing and Installing Parts
99