Error Messages - Dell Dimension 9200 Owner's Manual

Error Messages

If the error message is not listed, see the documentation for the operating system or the program that
was running when the message appeared.
F I L E N A M E C A N N O T C O N T A I N A N Y O F T H E F O L L O W I N G C H A R A C T E R S
A
use these characters in filenames.
A R E Q U I R E D . D L L F I L E W A S N O T F O U N D
essential file. To remove and then reinstall the program:
1
Click Start, click Control Panel, and then click Add or Remove Programs.
2
Select the program you want to remove.
3
Click the Change or Remove Program icon.
4
See the program documentation for installation instructions.
A L E R T ! A I R T E M P E R A T U R E S E N S O R N O T D E T E C T E D
Press F1 to continue or F2 to enter system setup.
drive letter : \ I S N O T A C C E S S I B L E
Insert a disk into the drive and try again.
I N S E R T B O O T A B L E M E D I A
N O N - S YS T E M D I S K E R R O R
O T E N O U G H M E M O R Y O R R E S O U R C E S
N
windows and open the program that you want to use. In some cases, you may have to restart your
computer to restore computer resources. If so, run the program that you want to use first.
O P E R A T I N G S YS T E M N O T F O U N D
— The program that you are trying to open is missing an
. T H E D E V I C E I S N O T R E A D Y
— Insert a bootable floppy or CD.
— Remove the floppy from the drive and restart your computer.
L O S E S O M E P R O G R A M S A N D T R Y A G A I N
. C
— Contact Dell (see "Contacting Dell" on page 137).
: \ / : * ? " < > | — Do not
— The ambient thermal sensor is not detected.
— The drive cannot read the disk.
— Close all
Solving Problems
53