Panasonic CS-Z20VKR Service Manual page 69

12.4.2 Attached Accessories
No. Name
1 Remote controller
Remote controller cable
2
Screw
3
(M4 machine pitched – 30 mm)
Screw
4
(M4 self tapping – 14 mm)
Remote controller cable holder
5
Screw
6
(M4 self tapping – 10 mm)
Screw
7
(M3 self tapping – 8 mm)
Screw
8
(M4 self tapping with washer)
12.4.3 Selecting the Installation Location
Upper case
Lower case

Allow sufficient space around the remote controller 1 as shown in the illustration above.

Install in a place which is away from direct sunlight and high humidity.

Install in a flat surface to avoid warping of the remote controller. If installed to a wall with an uneven surface,
damage to the LCD case or operation problems may result.

Install in a place where the LCD can be easily seen for operation. (Standard height from the floor is 1.2 to
1.5 meters.)

Avoid installing the remote controller cable near refrigerant pipes or drain pipes, else it will cause electrical shock
or fire.
Qty
1
1
3
3
1
1
1
1
Remote controller
Diagram
Length (9.9 m)
Installing the remote controller to an outlet box
(embedded cable)
Installing the remote controller to the wall
(exposed cable)
Holder for remote controller cable at control board
Tighten remote controller cable with holder
Installing the remote controller cable to control board
Installing the green wire to terminal board complete
30 mm
or more
30 mm
or more
120 mm
or more
69
Remark
30 mm
or more
Remote
controller
lower case