MasterCraft 55-6863-0 Operating Manual page 7

SPECIFIC SAFETY RULES
Use only crosscutting saw blades. When using carbide-tipped blades, make sure
that they have a negative hook angle.
IMPORTANT: Do not use thin-kerf blades. Thin-kerf blades can deflect and contact
the guard, which can cause possible injury to the operator.
Do not operate the Mitre Saw until it is completely assembled and installed
according to these instructions.
If not thoroughly familiar with the operation of Mitre Saws, seek guidance from a
supervisor, instructor, or other qualified person.
Always hold the work firmly against the fence and table. Do not perform any
operation free hand; use a clamp or vise whenever possible
Keep hands out of the path of the saw blade. If the work piece causes the hands to
be within the "no hands" zone (3'' (7.6 cm) from the blade), the work piece should be
clamped in place before making the cut.
Be sure that the blade is sharp, runs freely, and is free of vibration.
Allow the motor to come up to full speed before starting a cut.
Keep the motor's air slots clean and free of chips or dust.
Always make sure that all adjusting knobs are tightened before cutting, even if the
table is positioned in one of the positive stops.
Be sure that both the blade and the flange are clean and the arbour bolt is tightened
securely.
Use only blade flanges specified for this saw.
Never use blades larger or smaller in diameter than 10 inches (25.4 cm).
Never apply lubricants to the blade while it is running.
Always check the blade for cracks or damage before operation. Replace a cracked
or damaged blade before further use.
Never use blades recommended for operation at less than 5000 RPM.
Use the blade guards at all times.
Always keep the blade guards in place.
Never reach around the saw blade.
Make sure that the blade is not contacting the work piece before the ON/OFF switch
is turned ON.
IMPORTANT: After completing the cut, release the power switch and wait for the
blade to stop before returning the saw to the raised position.
Make sure that the blade has come to a complete stop before removing or securing
the work piece, changing the work-piece angle, or changing the angle of the blade.
Never cut metals or masonry products with this tool. This Mitre Saw is designed for
use on wood and wood-like products.
Never cut small pieces. Keep hands outside the no-hands zone: at least 3" (7.6 cm)
from the blade.
Provide adequate support to the sides of the mitre table for long work pieces.
Never use the Mitre Saw in an area with flammable liquids or gases.
Never use solvents to clean plastic parts. Solvents could possibly dissolve or
otherwise damage the material.
Shut off the power and unplug the tool before servicing or adjusting the tool.
Disconnect the saw from the power source and clean the tool when finished using it.
7