MasterCraft 55-6863-0 Operating Manual page 14

MOUNTNG THE MITRE SAW TO THE STAND
1. Check the Mitre Saw for the number of mounting holes and their location.
2. Choose the corresponding hole locations on the Tabletop Assembly of the
Mitre-Saw Stand.
3. Change the width of the Tabletop Assembly, if necessary, to accommodate the
Mitre Saw. To change the width of the Tabletop Assembly, see
in Unfolding and Setting Up the Mitre-Saw Stand.
4. Place the Mitre Saw on the Tabletop Assembly, align
the mounting holes in the Mitre Saw with the holes on
the Tabletop Assembly, and use the bolts and nuts
(included) to connect them, as shown in
FOLDINGTHE MITRE-SAW STAND FOR STORAGE
(Refer to Illustration
1. Remove the Mitre Saw from the Mitre-Saw Stand.
2. Loosen the Mitre-Saw Stand's Clamping Knobs.
3. Open the Tabletop Assembly to its fully extended size,
and re-tighten the Clamping Knobs.
4. Pull back the Spring-Loaded Locking Pin, and remove
the Support Bar from the Tabletop groove.
5. With one foot on the Base Bar, raise the Tabletop
Assembly to the upright, vertical position.
6. Close up the legs of Mitre-Saw Stand and push down
on the Chrome Extension Bars until they are fully
lowered.
7. Lower the Tabletop Assembly.
8. Use the yellow Locking/Carrying Handle to join the Tabletop Assembly and Legs
together.
WARNING: To reduce the risk of injury, always unplug tool before attaching or
removing accessories or making adjustments. Only use specifically recommended
accessories.
Installation of dust bag (see Fig.17)
Squeeze the metal collar wings on the dust bag, and
place the bag's
dust-extraction port. Release the metal collar wings.
Figs. 3 to 15 on pages
neck opening around
(Fig.16)
Fig. 16.
11-12)
Fig. 16
Fig.17
the
Figs. 3 through 15
Dust bag
Dust
extraction
port
14