Advertisement
Dear music lover,
Thank you for purchasing a Pro-Ject Audio Systems record cleaning machine.
In order to achieve maximum performance and reliability, please study these instructions carefully.
Warning of a hazard for the user, the unit or possible misuse.
Important notice.
During assembly and adjustment small parts can be easily lost if they are not carefully placed in a suitable
receptacle. Before beginning assembly, please familiarize yourself with the parts listed above which are
correspondingly numbered in the technical diagram. Separately packed items are marked with an asterisk*.
Safety instructions
This appliance is not to be used by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction.
AC outlet voltages vary from country to country. Before connecting to your wall outlet, make sure that
the voltage in your area meets the voltage requirements printed on the device.
Hold the end of the plug when unplugging the power cord. Never handle the power cord while your
hands are wet or damp.
Never place any open flame sources, like burning candles, on or near the device. Do not operate in
damp or wet locations, such as near to a bathtub, sink, swimming pool or any other similar locations.
Keep plastic bags away from children to prevent any risk of suffocation.
Do not cover any ventilation holes (one is located on the left side and others are on bottom).
During operation this unit will generate loud noises, so we recommend the use of hearing protectors
during longer cleaning sessions. Check the unit after transportation for signs of damage, if a damage
is found, do not operate the unit and contact your dealer!
The unit is capable of long time running however in such case platter spindle may get hot and whole
platter/clamp area as well as air coming out from the unit may get warm. The temperature of the
platter can´t damage vinyl records. In order to keep the temperature as low as possible do not
expose the unit to direct sunlight.
Motor should not be turned on when not cleaning your records. Extended running time outside of the
guideline process can cause over-heating.
Setting up the unit
The unit is supplied assembled with the exception of the platter and vacuum arm which are packed
separately. Remove all parts from the transport packaging carefully. Please see the diagram above for
assembly instructions. Base part of the clamp (2) should be attached by using the screw (3), a Phillips
head screwdriver is required but not included. Then apply the self-adhesive label seal (13) on top.
This product is only for non-commercial use.
Using the unit
Please ensure that all assembly and set up steps have been followed as outlined in this manual. All
3 rocker switches ("main switch", "motor" and "vacuum" should be in position "0"). Connect the
power cord to the socket on the rear side of VC-S2 and turn the main switch to the "I" position.
Place a record on the bottom plate. Using moderate force, thread the top clamp plate on the
threaded tip of the centre spindle. Do not over-tighten. If the top plate and screw clamp are too
loose, the record will not turn even if the motor is running.
4
© Pro-Ject Audio Systems · VC-S2 ALU (from S/N:19F011632) · Revision 2019.10.19
Advertisement
